Bebob Hot Swap Adapter for ARRI Alexa Mini and mini LF

Bebob Hot Swap Adapter for ARRI Alexa Mini and mini LF.

The Bebob ML-120ALEX MINI is a hot swap adapter for ARRI Alexa Mini. The V-Mount adapter draws a maximum of 15A and powers the camera without interruption for 120s. The adapter weighs only 0.52kg.

Charging

• The ML-120ALEX MINI charges itself from the V-Mount battery
• At first charge or If completely empty, the ML-120ALEX MINI will be ready to use after 60 minutes
• While Ccharging the yellow "Charging" LED turns on
• When fully charged the green “Ready“ LED turns on
• The ML-120ALEX MINIcharges itself automatically when needed.
• During charging The ML-120ALEX MINI keep monitoring the voltage of the battery and is ready to switch if needed

 Battery Swap

• The ML-120ALEX MINI detects a battery as empty when the voltage drops below 12,5V
• The ML-120ALEX MINI instantly takes over powering the ARRI Alexa Mini and the D-Tap port for a maximum of 2 minutes and displays a red LED alarm
• The LED Alarm flashes for 90s, turns to solid for the last 30s.
• After the empty battery has been replaced by a charged one (voltage under load of over 14,5V), powering of the ARRI Alexa Mini instantly reverts to the V-Mount battery.
• The ML-120ALEX MINI switches up to 6 Times before running empty
• If the empty battery is not replaced within 2 minutes the ML-120ALEX MINI and the ARRI Alexa Mini will switch off.

Alarm LED´s brightness

• To allow the Alarm LED to be visible in bright environments (sunlight etc.) but not disturbingly over bright in darker environments (studio etc.), the ML-120 has automatic brightness adjust.
• The brighter the environment the brighter the alarm LED will show.
• The environment light detector is located at the top – middle of the ML-120 housing.
• Covering the housing (with tape for instance) will switch off the automatic brightness adjust and the alarm LED will flash with minimum brightness

Safety instructions

• Only for professional use! Keep Charger out of reach of children and personnel that has not been instructed in the use!
• Use only with recommended batteries.
• Keep the ML-120ALEX MINI dry and do not immerse in water.
• Do not attempt to open or repair the ML-120V7V. Contact your dealer for help if it becomes defective.
• Handle with care! Do not throw! Do not drop!